Installation Guide - Preparation

Getting Help

If you run into problems installing this kit, please email hovrllc@gmail.com for support. Please

 1. Include your Airstream's model/year.

 2. Describe the problem in details, pictures can be very helpful.

Tools required

    • Tape Measure
    • Electric Drill Driver
    • 1/16" drill bit
    • Screw Driver
    • Utility Knife
    • Dry-erase marker or pencil

Tools required

Door removal

It's highly recommended to remove the closet door before installation. This would provide much easier access to the closet and prevents damage to the door hinges. To remove the door, remove all 6 screws (2 for each hinge) from bottom to top. Note - remove the screws on the wall, not the screws on the door 

Clean the wall

Use paper towel and household spray cleaner to clean the closet walls. 

 

Get Familiar with Parts

Stainless rods

Your kit comes with 2 sets of stainless rods, the longer ones are for upper shelvings and the shorter ones are for lower shelvings.

Screws

There are 2 sets of stainless screws, one set of #6 - 5/8 screws, the other set (only 3) are #6 - 3/4 (longer),  you will be using 2 of the 3/4" screws for 2 front brackets  of lower shelving. the extra one is provided in case you lost one. 

 3D printed Brackets

On the back of 3D printed brackets, there are letters
* The first letter indicates (U)pper or (L)ower shelving
* The second letter indicates (L)eft or (R)ight
* The third letter (if presents) indicates (F)ront or (B)ack

Removing support material from 3D printed brackets

The joint of upper front brackets has support material that needs to be removed before installation:

Most of it can be peeled off, and the remaining can be removed with a utility knife:

After you remove it, you should be able to create a flush joint with front and back bracket as shown below:

Visualize shelvings 

Use the follow rendering to visualize how all parts fit together

Upper shelvings

Lower shelvings

Double sided tape backing

A small roll of double sided tape is included in the kit, please apply about 3 inches  to the back of each brackets. It helps place the bracket on the wall before they are screwed onto walls. It also provide additional shear strength once the brackets are screwed onto wall.  Note they are non-permanent tape so they can be removed without damaging wall surfaces.

Next: Upper Shelvings